Thursday, November 22, 2012

Who Sells Sheap ALEKO® WG300 12-Volt 6-Blade 300 Watt Wind Generator With Charge Controller

ALEKO® WG300 12-Volt 6-Blade 300 Watt Wind Generator With Charge Controller

ALEKO® WG300 12-Volt 6-Blade 300 Watt Wind Generator With Charge Controller

Code : B004WMD5MW
Category :
Rating :
HOT OFFERS
* Special discount only for limited time










Product Details

  • Amazon Sales Rank: #114204 in Lawn & Patio
  • Brand: ALEKO®
  • Model: WG300 12V
  • Dimensions: 29.00 pounds

Features

  • Low wind speed model.
  • This model starts producing the wind energy just from 5 mph wind.
  • This is the latest design with 6 blades.
  • Quiet in operation, Brushless alternator, 360 degree free rotation on the mounting pole
  • Comes with integrated charge controller, instruction manual and 1-year warranty.





ALEKO® WG300 12-Volt 6-Blade 300 Watt Wind Generator With Charge Controller









Product Description

The GudCraft WG300 12V is popular low start up wind speed wind turbine in home yard, cabins, boats, advertising signs, telecommunications tower, etc. Thousands have been sold and are in use worldwide. People have the particular inclination for it�s clean, aerodynamic lines and its quiet and continuous operation. Without any doubt GudCraft WG300 accumulates more energy than any other comparable wind generator available, you�ll always see spinning in the lightest of breezes.





   



Customer Reviews

Most helpful customer reviews

17 of 17 people found the following review helpful.
2Gudcraft WG300 Review
By DJM, Oxford, MA
Gudcraft WG300 - I hooked it up to a new partially discharged 12 volt deep cycle battery at 12.74 VDC.It's been hooked up for two weeks now and the battery voltage hasn't raised even a hundredth of a volt yet.Not that the turbine hasn't been spinning, it has! It spins in a very mild wind; it just doesn't produce 12 volts until it is spinning so fast that you can't see the blades. I've had 15 MPH wind gusts with no charging. Tests I have run indicate it has to be spinning 4 to 5 revolutions per second to output 10 VDC.That's about 250 RPM, and moving pretty quickly, above that speed the black dot Indicator I put on the center hub begins to blur and speed measurement becomes difficult. Fearing the unit was defective I took all the blades off and mounted it and spun it manually as fast as I could and managed to get it to 12 volts after a few tries, and finally up to 17 volts for a moment. So it is capable of putting out the proper voltage to charge a battery. Since I was only able to get it going that fast for a moment I was unable to measure the current output.Today it's been windy all day and it's been spinning most of the time, but there has been no charging yet, save your money.Update, today we had sustained 30 MPH winds with gusts up to 50MPH and the wind turbine was able to charge a single deep cycle battery from 12.75 volts up to 13.25 volts with a highest current of 0.7 amps. Since I'm not likely so see many days with these kind of winds, it falls very short of it's rated 300 watts or 25 amps. I still wouldn't recommend it to anyone. The wind speed was checked with a Lacross weather station anemometer. It rarely puts out 12 volts and so far never more than 1 amp. Actually today is the first time I was able to measure any current output at all. It's moving so fast today, I can't see the blades, they are just a blur.

9 of 9 people found the following review helpful.
1Produces Voltage, but will not charge a 12V battery
By Finish Line PDS
Will not charge a 12V battery. We had this in 50 MPH winds, and the best we could get was 12.45V - a fully charged flooded lead acid cell (car battery) is 14.6VDC (at room temp).We tried two different units with the same result.We connected it to an oscilloscope and we see a full wave rectified sine wave output with a peak voltage of 12.5V. So it does not appear to have bulk, absorption, float control - which is really important if you want the battery to last for any length of time. I think the "charge controller" is noting more than a full wave retifier - which is not going to maximize the battery life and/or fully charge the battery.Might work to charge a 6V battery, but not a 12V battery. Even if you only have a 6V battery, you will still need a charge controller - as connecting directly will overcharge the battery. Such a controller would necessarily have to deal with the voltage this device generates - so it would likely have to be a custom one.

8 of 9 people found the following review helpful.
4wind power
By swan
the wind generator is werking fine but laks the abilaty to charge more than two baterys at a time at low wind speeds it only poots out six volts and at higher wind speed it reches about ten volts i have yet to see it poot out 12V or more

See all 4 customer reviews...



ALEKO® WG300 12-Volt 6-Blade 300 Watt Wind Generator With Charge Controller. Reviewed by Eric G. Rating: 4.5

This Page is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED "AS IS" AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Share

Twitter Delicious Facebook Digg Stumbleupon Favorites More